FS: 2006 Audi A4 2.0T Parts / Engine Rebuild
#1
FS: 2006 Audi A4 2.0T Parts / Engine Rebuild
500$ obo as-is. Silver with black interior 2006 Audi A4 front wheel drive w/ cvt transmission. 240,000km.. Engine doesn't run. Car is located in Burlington. The car is stock but had an electronic car starter installed last year. Other than the engine all other parts are working. The body has 2 or 3 rust spots starting but other than that it is in good condition. I will send to the auto wreckers if there is no interest.
I was on the 407 the other day and lost power. I had my mechanic look at it a little bit and one of the camshafts is spinning freely so there is some internal damage to the engine. I'm not paying for him to investigate further as I don't think it will be worth it to pay to have it fixed.
Here are the error codes that existed when the engine failed (cooling problem was pre-existing - it needed a new thermostat):
Fault log report generated by Torque for Android
=================================================
Vehicle Manufacturer: Audi
Vehicle Calibration ID: Not present
Current Fault Log
------------------
P2181: Cooling System Performance
Pending Fault Log
------------------
P0343: Camshaft Position Sensor "A" Circuit High Input (Bank 1 or Single Sensor)
P0101: Mass or Volume Air Flow Circuit Range/Performance Problem
P0299: Unknown code - More information may be available on the web
P12A1: Unknown code - More information may be available on the web
End of report.
I was on the 407 the other day and lost power. I had my mechanic look at it a little bit and one of the camshafts is spinning freely so there is some internal damage to the engine. I'm not paying for him to investigate further as I don't think it will be worth it to pay to have it fixed.
Here are the error codes that existed when the engine failed (cooling problem was pre-existing - it needed a new thermostat):
Fault log report generated by Torque for Android
=================================================
Vehicle Manufacturer: Audi
Vehicle Calibration ID: Not present
Current Fault Log
------------------
P2181: Cooling System Performance
Pending Fault Log
------------------
P0343: Camshaft Position Sensor "A" Circuit High Input (Bank 1 or Single Sensor)
P0101: Mass or Volume Air Flow Circuit Range/Performance Problem
P0299: Unknown code - More information may be available on the web
P12A1: Unknown code - More information may be available on the web
End of report.
Thread
Thread Starter
Forum
Replies
Last Post
ababina
Eastern Canada discussion
6
01-28-2009 01:40 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)