GT2871R Eliminator setup on my B6 A4 1.8 Quattro
Thread Starter
Audi Forum - Posts like an A5
Joined: Jan 2011
Posts: 309
From: Montréal
Re: GT2871R Eliminator setup on my B6 A4 1.8 Quattro
Setup is finally done, got the tune for 91 octane since im often on the road. I burnt my stock clutch in one weekend ... (Coulnt handle the power and I there was 1 feet of snow where I was)
Good thing I already had my RS4 disc, pressure plate, bearing and lightweight single mass flywheel
<
I wanted to keep my stock Intake, but had to get rid of it because of the TT map sensor
I will also need to install resonators on my exhaust line, that thing is loud now!
Cheeba : After reading a lot I noticed people tend to make hole in their blocks more with K04's then with the gt2871rs because of the low end torque?? Thoughts?
Good thing I already had my RS4 disc, pressure plate, bearing and lightweight single mass flywheel
<I wanted to keep my stock Intake, but had to get rid of it because of the TT map sensor
I will also need to install resonators on my exhaust line, that thing is loud now!
Cheeba : After reading a lot I noticed people tend to make hole in their blocks more with K04's then with the gt2871rs because of the low end torque?? Thoughts?
Last edited by Axis; Jan 31, 2012 at 07:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
