prabhakarglv

Hi,

I bought Kenwood DNX6490BT Navigation/Audio unit for my 2002 Audi Allroad Quattro. I have the following connectors other than radio unit.

1. Metra (70-1787)AUDI VW AMP INTEGRATION HARNESS
2. SWI-JACK
3. SWI-CAN2

There are couple of questions I have,

1. I try to install it today using SWI-JACK and SWI-CAN2. However I'm confused to connect the wires I mean waht wires I should connect in between these two modules.

2. There is a red colour connector in Metra (70-1787) harness (Once side it's have RCA jacks and in the manual it says like Use the White, White/Black, Gray, and Gray/Black speaker wire for the front speaker output and use the Green and Purple
RCA’s for the rear speaker outputs in THE AFTER MARKET RADIO. The other side its have RED CONNECTOR). To which connector in my car should I've to connect with this, because I couldn't able to figure out the correct connector for this red connector in my car?

3. Need I've to buy any other connectors?

I already did couple of after market radio installations in my other cars and motor home and all those installations were successful. This one is making me confusion with TWO modules.

Please advise me in simple instructions for the istallation of radio. I would appreciate your help. Thank you,

Regards,

Pubby.