Hello Audi fans

I have installed a REVO stage 1 remapping on my 2004 A4 1.8t Quattro Avant 6 spd. For some reason the same day I started having issues shifting through the gears. Up shifting is very knotchy even with the clutch pedal fully pressed and the higher the revs the worst it is. For it to be smoother I have to shift below 3000 rpm.
Down shifting is worst, cannot drop two gears if I want to, it will not engage. I have to go gear by gear and bump up the revs to match with engine speed when clutch is pressed. I cannot just clutch and drop a gear , it will not engage until I bump up the revs. I checked the fluid level and it's good. I would like your thoughts. Change the clutch and tranny fluid? Clutch change? Syncros? Why aft the Revo remapping, before is was pretty smooth.

I have seen a few problems about this and sometimes a clutch change did the trick. Am I due for one as well with 130000km?

 

i wouldnt say you are necessarily due for one... changing the hydraulic clutch fluid might be a good idea to try, if it has never been done.
i am sure it has nothing to do with the tune.
perhaps syncros, perhaps clutch master/slave cylinder?

 

I thought about that. But some are telling me my pressure plate may have an issue. thanks for the advise

 

bleed your clutch master cylinder or adjust the clutch pedal first.

 

okay i'll try that first as well as change the fluid. Should i change the slave
thanks again for the support

 

just bleed and look if the pedal doesn't need to be adjusted because it looks like your clutch is draging.

 

I'll do it next week. It's a real pain in the A** to drive like this