Tire Pressure Sensors
I have OE Pirelli 255/40R19 tires on my 2006 A8. For winter driving I replaces them with an 18" set of chrome wheels and 235/50R18 Nokian Hap. The Nokian tires are great for Quebec winter driving. Unfortunately I don't have tire pressure monitoring sensors on the winter wheels...thus the annoying sensor warning. My dealers don't know how to turn it off. Any advice/comment would be much appreciated.
Cheers |
Re: Tire Pressure Sensors
Well you can get some tire pressure monitoring sensors on the winter wheels.
|
Re: Tire Pressure Sensors
Originally Posted by didi
(Post 84294)
I have OE Pirelli 255/40R19 tires on my 2006 A8. For winter driving I replaces them with an 18" set of chrome wheels and 235/50R18 Nokian Hap. The Nokian tires are great for Quebec winter driving. Unfortunately I don't have tire pressure monitoring sensors on the winter wheels...thus the annoying sensor warning. My dealers don't know how to turn it off. Any advice/comment would be much appreciated.
Cheers What you should be aware of is this. Measure the circumference of your original tires and match the new setup with something very close. If you don't, expect the speedo to read incorrectly and the ABS controller to do the same. |
Re: Tire Pressure Sensors
If you have direct TPMS then you will need 4 sensors/valves for your winter wheels. I ordered 4 from Tire Rack for my other car.
Wheel diameter only applies to indirect TPMS. |
Re: Tire Pressure Sensors
Measure the circumference of your original tires and match the new setup with something very close. If you don't, expect the speedo to read incorrectly and the ABS controller to do the same.
Here's an English calculation. The formula relating road speed and engine rpm is mph = (rpm X cir) / (gear X final X Eighty Eight) where rpm = engine rpm cir = tire circumference, in feet gear = gear ratio of your car final = final drive ratio of your car 88 = combines several conversion factors For example, an Audi 90 Quattro. Its tires are 195/60VR-14, so the calculated circumference works out to be 72.92 inches or 6.08 feet. Its final drive is 4.11:1, its 5th gear is 0.79:1, so their product is 3.25 and the rest is a quick calculation away: mph = (rpm X 6.Zero Eight) / (3.25 X Eighty Eight) = 0.0213 rpm Ie: the Audi will do 21.3 mph for every 1000 rpm in 5th gear. To work the equation the other way and to find engine rpm for a given road speed, you want to solve for rpm: rpm = (mph X gear X final X Eighty Eight) / circumference At 60 mph, the Audi is revving a calculated 2822 rpm, within a few percent of the computer's calculated 2750 rpm. |
Re: Tire Pressure Sensors
I think the 2006 A8 has direct pressure sensors inside the wheels, so no need for calculations. Red G8R is correct in assessing that for direct pressure read sensors, all you may need is additional, newly installed sensors that radio transmit the pressure reading. These sensors will need to be compatible with the TPMS receiver so that will neeed to be examined. Older systems measured pressures by counting tire revolutions/rotations compared with other wheels. Low pressure meant more rotations so an alarm was generated. No exact pressure reading was provided. That was how indirect systems operated. Direct pressure reading systems circumvent all of these problems. I'd order the OEM pressure sensors to ensure compatibility with the MMI/TPMS system in your A8. Ask dealer but check around for aftermarket parts as well.
|
Re: Tire Pressure Sensors
You might want to check the Audi World dot com Forums site. One the A8 D3 pages, an owner by the name of Brozee has show how to eliminate the TPS system on the MMI using the Ross-Tech VAG software, connector, and a laptop. I haven't done it, but it looks simple!
I'd post a link, but I haven't yet had 5 posts on this Audi Canada site! Send me a Private Message or an e-mail if you have trouble, and I'll send you the link. Gary-- |
Re: Tire Pressure Sensors
Originally Posted by Gary Knox
(Post 182853)
You might want to check the Audi World dot com Forums site. One the A8 D3 pages, an owner by the name of Brozee has show how to eliminate the TPS system on the MMI using the Ross-Tech VAG software, connector, and a laptop. I haven't done it, but it looks simple!
I'd post a link, but I haven't yet had 5 posts on this Audi Canada site! Send me a Private Message or an e-mail if you have trouble, and I'll send you the link. Gary-- I hope you did take note that the original post was from 10-05-2008, 04:12 PM no sense in responding to resolved issues 4 years ago |
Re: Tire Pressure Sensors
1Move,
Well, I didn't see that. BUT the post is there for anyone who might do a search on lowering an A8 in the future. New guy trying to be helpful, old eyes didn't look for or see the posted date!!! Gary- |
Originally Posted by Gary Knox
(Post 182869)
1Move,
Well, I didn't see that. BUT the post is there for anyone who might do a search on lowering an A8 in the future. New guy trying to be helpful, old eyes didn't look for or see the posted date!!! Gary- I'm still shocked at how unbusy this forum is though, lol. |
All times are GMT -5. The time now is 05:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands