2000 B5 S4 Front Seats Mint Condition!
 

Hey guys,

I'm selling my B5 S4 front seats only! Driver and Passenger they are in mint condition for how old they are. No rips and non smoker here :) I weigh 145lbs so there's barely any wear!

I took off my front seat today to start fitting my Recaro A8s in so these have to go! When I get a chance to take out the passenger seat I will take a picture but the passenger is in better condition than the driver since barely anyone since on them unless it's my girlfriend.

I'm asking 500 for both!

https://www.audiforum.ca/attachment....ine=1370728794

If you're interested please pm me.

Re: 2000 B5 S4 Front Seats Mint Condition!
 

Hi,
i may be interested. Do you know if they would be a direct fit into my 98 B5 A4Q? Or how to make them fit if it is possible? Thank you!

I have no idea. But i have seen people put them in. They're power and heated.

Re: 2000 B5 S4 Front Seats Mint Condition!
 

They are a direct fit. Even if you don't have power seats now, all the plugs you need are still in the car under the seats for the power option.

You just need to take your seats out, and bolt these seats in.

:thumb:

Re: 2000 B5 S4 Front Seats Mint Condition!
 

Hi Gerald,
Sorry for the delay, i am very busy. Where are you located. I am near Ottawa. Thanks to those who provided information re: fitting in my car.

Re: 2000 B5 S4 Front Seats Mint Condition!
 

Rob, the S4 uses a 4 point mounting system and non power A4's use the old 3 point slider. Matt tried to bolt these into his A4 with no luck. They will certainly fit, but you will need to mess around with the mounts. Erik, if your car has power seats these should fit right away, if they are manual slide you will need to do some work.

Re: 2000 B5 S4 Front Seats Mint Condition!
 

i ended up putting s4 seats into my non powered car. your going to have to do some welding and wiring work to get these in. if you have the 99.5 + model year its a little easier getting power. my car had the holes predrilled to mount he front part of the seats but werent threaded. i ended up welding a plate with a bolt in this location. the only other thing i had to do was bring power to the seats. all other connections were the same. So seats will fit just need a little modification to get them to function if your going from manual to power.