Anyone know if there is a way to "re-set" the trany after it goes into
"fail safe mode"?? I don't think there is anything wrong with the tranny
because it went into fail safe mode after I pulled a fuse while the car
was running and I also put the car in reverse with the emergency brake on
so I could check to see if my reverse lights were working. After I did
these two things the tranny won't shift out of 2nd gear. I read my manual
and it "talked" about a fail safe mode.

 

"audijlp" <rocapollo2@aol.com> writes:

> Anyone know if there is a way to "re-set" the trany after it goes into
> "fail safe mode"?? I don't think there is anything wrong with the tranny
> because it went into fail safe mode after I pulled a fuse while the car
> was running and I also put the car in reverse with the emergency brake on
> so I could check to see if my reverse lights were working.

Erh, I usually find a) someone that can help me. b) find a large window
that reflects the lights of the car and that way check all lights.

Other than that I cannot give you any advice as to how to get your
tranny out of safe-mode.

--
azoth@dod.no
------------------------------------------------------------------------
Wenn im Zweifel, Volleistung! DoD#2101
'93 Audi 100 2.3E When in doubt, floor it!

 

"audijlp" <rocapollo2@aol.com> writes:

> Anyone know if there is a way to "re-set" the trany after it goes into
> "fail safe mode"?? I don't think there is anything wrong with the tranny
> because it went into fail safe mode after I pulled a fuse while the car
> was running and I also put the car in reverse with the emergency brake on
> so I could check to see if my reverse lights were working.

Erh, I usually find a) someone that can help me. b) find a large window
that reflects the lights of the car and that way check all lights.

Other than that I cannot give you any advice as to how to get your
tranny out of safe-mode.

--
azoth@dod.no
------------------------------------------------------------------------
Wenn im Zweifel, Volleistung! DoD#2101
'93 Audi 100 2.3E When in doubt, floor it!

 

"audijlp" <rocapollo2@aol.com> writes:

> Anyone know if there is a way to "re-set" the trany after it goes into
> "fail safe mode"?? I don't think there is anything wrong with the tranny
> because it went into fail safe mode after I pulled a fuse while the car
> was running and I also put the car in reverse with the emergency brake on
> so I could check to see if my reverse lights were working.

Erh, I usually find a) someone that can help me. b) find a large window
that reflects the lights of the car and that way check all lights.

Other than that I cannot give you any advice as to how to get your
tranny out of safe-mode.

--
azoth@dod.no
------------------------------------------------------------------------
Wenn im Zweifel, Volleistung! DoD#2101
'93 Audi 100 2.3E When in doubt, floor it!

 

"audijlp" <rocapollo2@aol.com> writes:

> Anyone know if there is a way to "re-set" the trany after it goes into
> "fail safe mode"?? I don't think there is anything wrong with the tranny
> because it went into fail safe mode after I pulled a fuse while the car
> was running and I also put the car in reverse with the emergency brake on
> so I could check to see if my reverse lights were working.

Erh, I usually find a) someone that can help me. b) find a large window
that reflects the lights of the car and that way check all lights.

Other than that I cannot give you any advice as to how to get your
tranny out of safe-mode.

--
azoth@dod.no
------------------------------------------------------------------------
Wenn im Zweifel, Volleistung! DoD#2101
'93 Audi 100 2.3E When in doubt, floor it!