wire tap... help please
#1
wire tap... help please
hey guys,
i'm trying to install led strips and want to tap the wire's somewhere under the hood so that they remain on at all times that the ignition is on... originally I was going to use a wire-tap into the DRL's but after looking at the 14 wires that exit/enter the connector piece I decided to come on here first for some advice ... any help is much appreciated
edit: 2006 audi a4 2.0 T - essentially I'm just looking for a wiring diagram for the 14 pins...
i'm trying to install led strips and want to tap the wire's somewhere under the hood so that they remain on at all times that the ignition is on... originally I was going to use a wire-tap into the DRL's but after looking at the 14 wires that exit/enter the connector piece I decided to come on here first for some advice ... any help is much appreciated
edit: 2006 audi a4 2.0 T - essentially I'm just looking for a wiring diagram for the 14 pins...
Last edited by amar26; 02-23-2011 at 05:50 PM.
#2
Re: wire tap... help please
What sort of headlights do you have Bi-Xenon or halogen? I know for Bi-Xenon, the DRL's go off as soon as you turn the headlights on. Halogens - I think the DRL is high beam at reduced voltage, so that circuit also likely off when the headlights are turned on for normal operation.
#4
Re: wire tap... help please
do you think it would be possible to tap a single +ve LED wire into both the +ve DRL and +vecity lights so that when the switch is in 'auto' it will grab power from the DRL during the day time and when it switches to the xenons it will grab power from the citylight?
Thread
Thread Starter
Forum
Replies
Last Post
Boarder03
Audi S/RS Models
19
02-03-2011 02:37 PM
1BODAUDI
Performance Parts & Tuning
2
07-19-2009 04:14 AM
Stuart
Audi Mailing List
5
02-10-2004 07:56 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)