Shake with cold start
#11
Re: Shake with cold start
If it shakes on cold engine only you are OK. It is due to cold ATF.
In case it happens on hot engine you need maintenance. My mechanic says to replace it every 120 k because of moisture in it.
The thing to watch for is either it shakes when it changes gear ex from 2 to 3.
There could be just a slight little hesitation or so but this is very serious.
The whole thing there revolves around fluid valves and passages. They close and open in something like 1/100..00 of a second so your fluid must be perfect to accomodate that.
My mechanic says " well we have two choices either replace the fluid now or transmission later"
You be the judge.
In case it happens on hot engine you need maintenance. My mechanic says to replace it every 120 k because of moisture in it.
The thing to watch for is either it shakes when it changes gear ex from 2 to 3.
There could be just a slight little hesitation or so but this is very serious.
The whole thing there revolves around fluid valves and passages. They close and open in something like 1/100..00 of a second so your fluid must be perfect to accomodate that.
My mechanic says " well we have two choices either replace the fluid now or transmission later"
You be the judge.
Last edited by adamstasiak; 11-01-2010 at 04:51 PM.
#12
Re: Shake with cold start
When you put it in reverse there is additional load on the engine, just make sure there is no vacuum leaks. the Hoses by the coolant resevoir usually start wearing out and get soft. Also make sure you do not have oil sludging, as it takes the oil sometime to get into the camshafts.
#13
Re: Shake with cold start
When you put it in reverse there is additional load on the engine, just make sure there is no vacuum leaks. the Hoses by the coolant resevoir usually start wearing out and get soft. Also make sure you do not have oil sludging, as it takes the oil sometime to get into the camshafts.
Last edited by wmoor086; 11-01-2010 at 07:53 PM.
#14
Re: Shake with cold start
When you put it in reverse there is additional load on the engine, just make sure there is no vacuum leaks. the Hoses by the coolant resevoir usually start wearing out and get soft. Also make sure you do not have oil sludging, as it takes the oil sometime to get into the camshafts.
I'm getting the oil changed this week, so I'll let you know if theres any progress.
#15
Re: Shake with cold start
mine has the tiny little shack when i first turn it on in he morning and when backing out of the garage.... i notice because i can see the HID light with a little shake. lasts about 1 min. i also noticed the driver side door around the handle inside the door panel has a mini rattle. but after a min when im done backing up to drive its normally stopped.
the door rattle part is the part that pisses me off the most.
hope ya get it solved
the door rattle part is the part that pisses me off the most.
hope ya get it solved
#16
Re: Shake with cold start
Check by the coolant reservoir and the hoses at the back of the head as well. you may have to take off the coolant resevoir to look at the hose attached to the intake hose, listen for any kind of hissing sound. run your fingers over the vacuum hose to feel any air.
Thread
Thread Starter
Forum
Replies
Last Post
totallycute90
A4-B5 - (Typ 8D, 1994–2001)
4
03-20-2012 04:54 PM
dexter
A4-B6 - (Typ 8E/8H, 2001–2005)
6
07-11-2008 02:51 PM
jake@rakestraw.com
Audi Mailing List
28
05-04-2007 01:48 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)