Can't get jack back into case (2003 A4 Avant)
#1
Can't get jack back into case (2003 A4 Avant)
I can't get the jack back into it's case. I have compressed the jack down and made it as small as I can, but when I put it into the mount in the trunk, the cover won't fit snugly over the top, which means that the floor panel won't sit flush when screwed down.
A small issue, but it's been bugging me since I bought this last year - it was like that when I bought it and I've not been able to figure out what I am doing wrong.
Could someone be kind enough to post pictures of the jack as it should be?
This is a 2003 A4 Avant.
A small issue, but it's been bugging me since I bought this last year - it was like that when I bought it and I've not been able to figure out what I am doing wrong.
Could someone be kind enough to post pictures of the jack as it should be?
This is a 2003 A4 Avant.
#2
Re: Can't get jack back into case (2003 A4 Avant)
I can sympathize. It's a pita for sure. Looking at your 3rd pic you need to rotate the handle 90 degrees clockwise. Towards the back of the case. Good luck!
#4
Re: Can't get jack back into case (2003 A4 Avant)
Can post a picture if it's really needed.
#5
Re: Can't get jack back into case (2003 A4 Avant)
I got it in. It was as described - the crank handle needed another quarter turn to the right, plus I had to give it some physical encouragement so that the black plastic **** on the crank sat flush against the body of the jack. Now it fits into the case no problems.
Thanks for the help.
Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post
S4Magic
Audi S/RS Models
14
11-02-2010 06:56 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)