A4 3.0 new clutch, new problem
#1
A4 3.0 new clutch, new problem
Hi Guys,
I just had my clutch and flywheel replaced 2 weeks ago. Ever since then, it's been tough to get my car in 1st gear or reverse when the car is at a stand still. When it's rolling the shifting is smooth as silk. Any ideas? Could there have been a problem with the clutch install? Or maybe my syncro's are going?
Thanks
I just had my clutch and flywheel replaced 2 weeks ago. Ever since then, it's been tough to get my car in 1st gear or reverse when the car is at a stand still. When it's rolling the shifting is smooth as silk. Any ideas? Could there have been a problem with the clutch install? Or maybe my syncro's are going?
Thanks
#3
Re: A4 3.0 new clutch, new problem
Hi Sean,
Thank you for the reply but I'm not sure what you're talking about buddy. It the slave the component that holds the hydraulic fluid for the clutch?
Thank you for the reply but I'm not sure what you're talking about buddy. It the slave the component that holds the hydraulic fluid for the clutch?
#4
Re: A4 3.0 new clutch, new problem
the slave is bolted to the transmission and actuates the clutch fork in the transmission, if there is air in there the air will compress and not allow full extension of the slave causing hard to engage gears when the cars not moving
Thread
Thread Starter
Forum
Replies
Last Post
Codyguthrie39
A4-B5 - (Typ 8D, 1994–2001)
2
07-02-2012 03:57 PM
mack1time
A4-B6 - (Typ 8E/8H, 2001–2005)
13
04-26-2010 09:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)