visaman

Does anyone have a "how to" on a Audi 80 2.6 liters v6 1993 mod ?
the engine code is ABC.
The engine is stock.

The items i have is:

Megasquirt II , 3.0 Main Board, set up for Hall sensor and dual MAP
sensors installed.
MSD 6AL ignition
standard injectors
4 MSD 72 lb/hr injectors, rated for alcohol.
Innovate LC-1 Digital Wideband Controller with Sensor.
DIY autotune relay card with cable to MS box.

I want to obtain the correct ECU connector, i think it is a bosh 80 pin,
so i can use the standard sensors and the standard connector.
this is because if something goes wrong with the MS2 box, it is possible
to just plug it out and replace it with the standard one.

Does anyone have the pinout for the connector ?

I want to run fuel and ignition.