tru2hapi

You can take off the plastic cover, the new problem are the three screws. They are installed on the inside of the bumper. You can not get to them without removing the bumper.

I just bypassed all of this and reached in behind the bumper and changed the fog lights. You might really small hands to accomplish this or your hands might get a little cut up.

Hope this helps anyones..

asutherland

FYI the bulb for 2002-2006 Audi A4 foglight is H11

Costner

Hi folks.

I know this thread is a little old, but anyway.....
And yes, i have two big Norwegian viking hands )

To replace bulb in a ordinary B7 frontbumper you need to remove the bumper,
that because of the bulb on the driver side( and big hands ).
Or you can do what i have done when i replace my bulbs with xeonlook bulbs in my B7, and make it a lot easier to change bulbs in the fogs in future
I drove my car up on two woodplanks on eace side ca.15cm.

You had to demount the black plastic frontplate under the car (just the screw in front of plate)
Now you can replace the bulb on passenger side.
Get a "dremler", move to the driver side.
Now you can see the aircanal to the intercooler are covering the foglight.
Take that dremler with a cuttingwheel on and cut a square opning in it underside so your hand can pass .
Now you can replace the bulb on the driver side.
After you have done that, find some stiff plastic and cut out a square bit, little bigger than that you cut away.
Mount it over the opning with two screws with wingmutters.
Next time you are going to replace a bulb here you just open the wingmutter and replace the bulb with a new one and close the opning,mount the frontplate, finish, simple

Hope you understood my bad english


Costner.

Louis Yong

Does the plastic grill just snap out and the screws are inside?

Louis Yong

Hope I don't have to remove the entire bumper to change the fog light!

a4audi4fun

Nope - looks like you have a B6 so all you need to do remove the actual fog light grill.

B7 with a stock bumper is the tricky one (small hands needed as above) or else complete bumper removal

B7 with S-Line bumpers (which includes all North American MY2008 A4) - just remove the fog light grill.

The foglight grills are held in place by 2 or 3 plastic tabs; look closely top and bottom and you will see them

Louis Yong

Thanks so much! Can you also explain what is B6 or B7 body type?
Mine is a 2005 A4 1.8L T engine...

a4audi4fun

B6 is model year 2001.5-2005 - has a small Audi front grill
B7 is model year 2006-2008 - has the large Audi front grill