Notices

My first post on the forum! (and a question)

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 10-06-2008, 09:40 PM
  #1  
Audi Forum - Posts like an A4
Thread Starter
 
asutherland's Avatar
 
Join Date: Oct 2008
Location: Victoria, BC
Posts: 114
asutherland is on a distinguished road
Default My first post on the forum! (and a question)

Hi everyone

I just purchased a new (to me) 2002 Audi A4 Quattro saloon car, loaded up with a lot of factory packages and addons. So far I LOVE it. I went from a 97 Integra to this. I'm located on Vancouver Island.

So this is my first post, saying hello and what-not. I'm definately not new to forum life, and even ran a forum a couple years ago. I'm also not a noob when it comes to tuning and mechanics (I claim enough to just make me dangerous) but I am definately new on the scene to Audi and VW.

So, I have a couple quick questions. As I mentioned, I am familiar with forum policy and therefore have definately searched for a while looking for my answer. However, can't seem to find it

1. My passenger side font signal (corner) light is out. The bulb needs replacing. How do I obtain access to the bulb housing?

2. The computer sees the driver's side door as -aways- open, even when it's not. I called the local Audi, who told me the entire door latch must be replaced at $200+ not including labour. Does anyone have a better option for me?

thanks, and I hope to be a positive influence on this forum!

Andrew
asutherland is offline  
Old 10-07-2008, 10:55 AM
  #2  
Audi Forum - Posts like a TT
 
sonic's Avatar
 
Join Date: Feb 2008
Location: waterloo
Posts: 696
sonic is on a distinguished road
Default Re: My first post on the forum! (and a question)

welcome to the wonderfull world of Audi.

for the lights....there is 4 bolts holding the light assembly in. If you look at the light with the hood open you will find them very easily. take them out, change the bulb, slide the unit back it. its actulay very easy to do. You may want to consider doing the clear corners when you are at it.

as for the door, just go to a junk yard. Car-Part.com--Used Auto Parts Market is a really good source.

however!!....i dont see how it can be a latch. It seems electrical to me and you need to find the source that is not grouding to complete the circut. it could just be rust or dirt on a contact patch. i will look at my door later...anyone else know the actulay sensor? is it just a plunger?
sonic is offline  
Old 10-07-2008, 11:10 AM
  #3  
Audi Forum - Posts like an RS4
 
Jazz's Avatar
 
Join Date: Nov 2007
Location: Barrie ontario
Posts: 871
Jazz is on a distinguished road
Default Re: My first post on the forum! (and a question)

i did that for a buddy on his A4, took me a long time!!! the 2nd time i did it was like 10/15 min you do need a long screwdriver
Jazz is offline  
Old 10-07-2008, 08:31 PM
  #4  
Audi Forum - Posts like an A4
Thread Starter
 
asutherland's Avatar
 
Join Date: Oct 2008
Location: Victoria, BC
Posts: 114
asutherland is on a distinguished road
Default Re: My first post on the forum! (and a question)

Originally Posted by sonic
welcome to the wonderfull world of Audi.

for the lights....there is 4 bolts holding the light assembly in. If you look at the light with the hood open you will find them very easily. take them out, change the bulb, slide the unit back it. its actulay very easy to do. You may want to consider doing the clear corners when you are at it.

as for the door, just go to a junk yard. Car-Part.com--Used Auto Parts Market is a really good source.

however!!....i dont see how it can be a latch. It seems electrical to me and you need to find the source that is not grouding to complete the circut. it could just be rust or dirt on a contact patch. i will look at my door later...anyone else know the actulay sensor? is it just a plunger?
Thanks, I will check that out for sure. As for the door, I can't find a plunger anywhere.
asutherland is offline  
Old 10-08-2008, 08:25 PM
  #5  
Audi Forum - Posts like an A4
Thread Starter
 
asutherland's Avatar
 
Join Date: Oct 2008
Location: Victoria, BC
Posts: 114
asutherland is on a distinguished road
Default Re: My first post on the forum! (and a question)

So, checked it out... do I actually have to REMOVE the light assembly from the car to change the bulb?

Just checking before I do...in case I do and it's for no good reason.

thanks!
asutherland is offline  
Old 10-09-2008, 09:28 AM
  #6  
Audi Forum - Posts like an A1
 
carinc's Avatar
 
Join Date: Oct 2008
Location: Clargy
Posts: 23
carinc is on a distinguished road
Default Re: My first post on the forum! (and a question)

Originally Posted by Jazz
i did that for a buddy on his A4, took me a long time!!! the 2nd time i did it was like 10/15 min you do need a long screwdriver
Well just visit a junk yard, you can easily and cheaply get it there , i would rather you suggest it
carinc is offline  
Old 10-11-2008, 12:24 PM
  #7  
Audi Forum - Posts like an A4
Thread Starter
 
asutherland's Avatar
 
Join Date: Oct 2008
Location: Victoria, BC
Posts: 114
asutherland is on a distinguished road
Default Re: My first post on the forum! (and a question)

Ok, so here's an update for changing the corner light: https://www.audiforum.ca/audi-a4/305...placement.html
asutherland is offline  
Old 10-13-2008, 11:10 AM
  #8  
Audi Forum - Posts like an A1
 
Ham14's Avatar
 
Join Date: Oct 2008
Location: Calgary
Posts: 2
Ham14 is on a distinguished road
Default Re: My first post on the forum! (and a question)

I too am new to the forum. I posted on hints and tips (perhaps wrong place). I just bought a 2007 audi (upgrade from 95 integra!) and don't have user manuals. Looking to use ipod integration, bluetooth and program my homelink but don't know how. Any help would be appreciated! Also anyone know where I can download manuals?
Ham14 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mistro
New Member Introductions
5
06-28-2011 06:25 AM
east.euro.10
New Member Introductions
9
03-24-2011 10:13 AM
jzh
Other Audi Models
0
02-22-2009 04:17 PM
Mikel
New Member Introductions
2
07-26-2008 11:49 AM
Buck
New Member Introductions
3
04-09-2006 07:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: My first post on the forum! (and a question)



All times are GMT -5. The time now is 12:31 PM.