Front Sway Bar removal Problem?
#1
Front Sway Bar removal Problem?
Hey Guys, I was trying to replace the Motor mounts on my car, and when i tried to remove the nuts that hold the brackets from the front sway bar to the engine support mount (i dont know the exact name), 3 of the bolts gave up or broke off front the engine support and now the bolts are moving around and the nuts cannot be remove.
What should I do? Should I cut the bolts and buy new ones? if so What kind of nuts and bolts? or Should I buy 2 new engine support mounts?
Thanks
What should I do? Should I cut the bolts and buy new ones? if so What kind of nuts and bolts? or Should I buy 2 new engine support mounts?
Thanks
Last edited by audia42k1.8tq; 09-10-2010 at 10:58 AM.
#3
Re: Front Sway Bar removal Problem?
Hey, i had to buy used engine support brackets and cut the bolts off, so that i can install the ones i bought, that was the best way i found to fix the issue..
hopefully that help you!!! if you have any other question just ask me
hopefully that help you!!! if you have any other question just ask me
#4
Re: Front Sway Bar removal Problem?
I need to get at the lower oil pan on my 2.8Q and the only way at the bolts is to remove the sway bar... I went to try, and one of the bolts just kept spinning... I wasnt sure if I could even get a wrench in there to take them off.
I am guessing this is what I will have to do to get at those bolts.
Chad
I am guessing this is what I will have to do to get at those bolts.
Chad
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)